Rockwell 1746-IB16 I/O模块现货特价

Follow these steps to install the module:
1.Disconnect power.
2.Align the circuit board of module with the chassis card guide. (A)
3.Slide the module into the chassis until the bottom tabs lock into place. (B)
4.Route the wires down and away from the module, securing them with the wire tie. (C)
5.Cover all unused slots with Card Slot Filler, catalog number 1746-N2, to keep the chassis free from debris.
6.To remove the module, press and hold the module release located on each self-locking tab, and slide the module out of the chassis slot. (D)
Module Installation
Max 2 mm2 (14 AWG)
Max 2 wires per terminal Max torque: 0.9 Nm (8 lb-in.)